Cube Acoustics tail gut

$75.00

Designed for better sound transfer when used with the Cube Acoustics endpins — which we do sell — and the housing, which can be ordered.  It is very strong, and may add a clarity to articulation and/or increase volume.   It is the same patented alloy in the tail gut tie block and wire as the endpin.

 

Category:

Related products

  • 10 mm Titanium Memminger endpin

    The Memminger hollow titanium endpin has five sets of 4 holes that spiral around the endpin every 90 degrees, about 1″ apart.    Length 23.5″, weight ~ 92 grams.

     

    $200.00

  • Angled Fitting for 10mm Endpin (NHM)

    Endpin fitting is composite/stainless with thumb screw. Cone diameter only comes in 27.5mm to accommodate the angle of the hole for a 10mm rod.  This allows use of a straight rod,angled downward 6 degrees.  Not as severe as the Stahlhammer’s 25 degrees.  Your cello sits more horizontal, f-holes facing more upward, and also may make the pegs sit more comfortably in relation to your neck.   Price is for the fitting only.  You can use any 10mm rod, or purchase the NHM 10mm rod (listed separately).

    $70.50

  • Bois d’Harmonie tailpiece

    French style tailpiece made from high-quality ebony, 235 mm long with integrated composite fine tuners.  Kevlar tail cord is available but not included because not everyone chooses this option.

    $295.00

  • Stahlhammer replacement tightener

    ** Read to the end – new update.  If you have overtightened the telescoping rod so it no longer holds, you have split the interior tightening mechanism.  This is a nylon sleeve and is replaceable.  Unscrew the extension rod and remove, take the tightening lock off, and gently screw the new one on.  Do not overtighten when you adjust your endpin next time.  Just enough to hold.   ***If you read the instructions inside the box, specifically No. 8, it suggests you routinely remove the inner tube and apply a few drops of alcohol to the nylon sleeve.  Apparently nylon off-gases, and produces a film which may act as a lubricant.  So even if you have not put oil in the mechanism, you still need to clean this part.  According to Semmy Stahlhammer, the nylon piece is strong and should not need to be replaced IF PROPERLY MAINTAINED.

    $14.00